Categories:
- AC Line Cord, Vintage Wires
- Adhesive/Tie Wrap And Cable Clamps
- Insulated Tape
- Battery Holder
- Capacitors
- Chassis Mounting Hardware
- Decals
- Dial Cords and Belts
- Dial Lamp Bulbs and Holders
- Dial Pointers
- Dial Scales
- Electrolytics
- Fahnestock Clips
- Felt Knob Washers
- Fuses and Fuse Holders
- Grille Cloth
- Hardware
- Heat Shrink Tubing and Fiberglass Insulation
- Hex Socket Set Screws
- Jack Plugs Pins and Spades
- Knobs
- Lubricants and Cleaners
- Miscellaneous and Discounted Items
- Phono and Tape Recorder Drives
- Plastic Dials
- Power Plugs
- Radio Antennas and Parts
- Radios and Equipment for Sale
- Record Changer Spindles, Adapters, Cartridges and Needles
- Resistors
- Schematics
- Solder Wire and Soldering Tools
- Speakers
- Stock Knobs, Plastic
- Strain Relief Clamps
- Switches, Volume Controls, and Volume Control Base Items
- Terminal Strips and Solder Lugs
- Test Meters and Cables
- Tools
- Transformers
- Transistors, Diodes and Accesssories
- Used Name Plates
- Vacuum Tubes and Accessories
Product successfully added to your cart. View Cart
-
Type 3AL5 7-pin miniature dual diode tube for series-heater television and radio detector circuits. Available in new and used condition.
3AL5 Vacuum Tube New and Used
$3.50Successfully Added to your Shopping CartAdding to Cart... -
Type 3AU6 7-pin miniature sharp-cutoff pentode tube for series-heater television and FM radio receiver circuits. Available in new and used condition.
3AU6 Vacuum Tube New and Used
$3.50Successfully Added to your Shopping CartAdding to Cart... -
Type 3BA6 7-pin miniature remote-cutoff pentode tube for series-heater television and FM radio receiver circuits. Available in new and used condition.
3BA6 Vacuum Tube New and Used
$3.50Successfully Added to your Shopping CartAdding to Cart... -
4-pin chassis mount vacuum tube socket for vintage radios and amplifiers, fitting Type 45, 80, 2A3, and standard UX-base 4-pin tubes.
4 Pin Tube Socket 01
$3.50Successfully Added to your Shopping CartAdding to Cart... -
5-pin surface mount wafer tube socket featuring 1 1/2 inch mounting hole spacing for vintage radio chassis and power supply components.
5 Pin Tube Socket 01, 02, 03
$3.50Successfully Added to your Shopping CartAdding to Cart... -
Duo-diode high-mu triode 7R7 loctal vacuum tube with a 6.3V heater rating, available in new old stock (NOS) or tested used options for vintage radio repair, detector-AVC, and audio preamplifier circuits.
7R7 Vacuum Tube New and Used
$3.75Successfully Added to your Shopping CartAdding to Cart... -
Type 1LD5 8-pin loctal diode-sharp-cutoff pentode tube for 1.4-volt battery radio circuits. Available in new and used condition.
1LD5 Vacuum Tube New and Used
$3.75Successfully Added to your Shopping CartAdding to Cart... -
Type 35Z3 8-pin loktal half-wave rectifier tube with pilot lamp tap for AC/DC radio receivers. Available in new and used condition.
35Z3 Vacuum Tube New and Used
$3.75Successfully Added to your Shopping CartAdding to Cart... -
4CS6 dual-control heptode vacuum tube for radio and TV mixer/converter stages, featuring a 4.2V heater and 7-pin miniature base.
4CS6 Vacuum Tube New and Used
$3.75Successfully Added to your Shopping CartAdding to Cart... -
6-pin chassis-mount tube sockets in molded Bakelite and low-profile wafer styles with 1-3/4 inch mounting hole spacing for vintage radio restoration and chassis repair.
6 Pin Tube Socket 01, 02
$3.75Successfully Added to your Shopping CartAdding to Cart...



